For full color correction: apply to dry hair. mix equal parts of colorfix part 1 color reducer and part 2 conditioning catalyst in tint bowl or an applicator bottle. (mix as much as will be needed for the density and length of hair that requires correction.) wearing gloves and using a tint brush, apply quickly and evenly to the hair. if mixed in an applicator bottle, shake vigorously until thoroughly mixed (45 seconds to 1 minute). gently work through the hair to ensure even penetration. after mixing part 1 color reducer and part 2 conditioning catalyst, use as quickly as possible, since the activity of the mixture decrease with time. cover loosely with a plastic cap, and process up to 20 minutes. strand test frequently. low, warm dryer heat may be used to speed processing time. rinse hair for 3-5 minutes and shampoo. if sufficient color is not removed, repeat step 2 and 3 (this may be done on damp, towel-dried hair). depending on condition of scalp and hair, do not repeat process more than 2-3 times. when desired level of color removal has been achieved, apply processing lotion for 5 minutes. (due to the nature of dye molecules, it is possible that hair may redarken to an unacceptable level. if it does, repeat steps 2-4 on damp hair, until sufficient color is removed.) rinse well. dry hair with a warm heat setting. (a hot setting may cause scalp irritation.) you may now proceed with your color application, if performing a full color corrective service. for slight color correction (lighten color that has gone too dark or ashen): mix 1/4 oz part 1 color reducer + 1/4 oz part 2 conditioning catalyst + 1 oz shampoo. wearing gloves, apply to damp, towel-dried hair. apply only to the areas of the hair that require lightening, and work into lather. to determine timing, take a strand test frequently. when the desired shade has been reached, rinse thoroughly and shampoo.

For full color correction: apply to dry hair. mix equal parts of colorfix part 1 color reducer and part 2 conditioning catalyst in tint bowl or an applicator bottle. (mix as much as will be needed for the density and length of hair that requires correction.) wearing gloves and using a tint brush, apply quickly and evenly to the hair. if mixed in an applicator bottle, shake vigorously until thoroughly mixed (45 seconds to 1 minute). gently work through the hair to ensure even penetration. after mixing part 1 color reducer and part 2 conditioning catalyst, use as quickly as possible, since the activity of the mixture decrease with time. cover loosely with a plastic cap, and process up to 20 minutes. strand test frequently. low, warm dryer heat may be used to speed processing time. rinse hair for 3-5 minutes and shampoo. if sufficient color is not removed, repeat step 2 and 3 (this may be done on damp, towel-dried hair). depending on condition of scalp and hair, do not repeat process more than 2-3 times. when desired level of color removal has been achieved, apply processing lotion for 5 minutes. (due to the nature of dye molecules, it is possible that hair may redarken to an unacceptable level. if it does, repeat steps 2-4 on damp hair, until sufficient color is removed.) rinse well. dry hair with a warm heat setting. (a hot setting may cause scalp irritation.) you may now proceed with your color application, if performing a full color corrective service. for slight color correction (lighten color that has gone too dark or ashen): mix 1/4 oz part 1 color reducer + 1/4 oz part 2 conditioning catalyst + 1 oz shampoo. wearing gloves, apply to damp, towel-dried hair. apply only to the areas of the hair that require lightening, and work into lather. to determine timing, take a strand test frequently. when the desired shade has been reached, rinse thoroughly and shampoo.